Boiler pilot light keeps going out in New York

Step 1 of 3: Equipment

Why does my boiler's pilot light keep going out?

A pilot that won't stay lit usually means it's happened more than once, and you're tired of relighting it every few days just to get heat back. In New York, with gas heat running the boiler through the cold months, a pilot that keeps quitting on you is worth taking seriously before the next cold snap finds you without it.

A dirty or failing thermocouple is almost always the cause

The thermocouple is the small rod that sits in the pilot flame and tells the gas valve the flame is lit. When it gets coated with soot or starts to wear out, it stops sending a strong enough signal, and the valve shuts the gas off as a safety measure. That's the pilot going out. A draft blowing across the flame or a dirty pilot orifice can cause the same thing, but a thermocouple that's worn out will keep failing no matter how many times you relight it. Since most homes in New York heat with gas, a boiler that won't hold a pilot through a cold stretch means no heat until it's fixed, and that part needs a hands-on look to know for sure.

A smiling bearded man in a dark green hooded jacket and blue t-shirt sits on a couch in a living room with shelves, a potted plant, and a bowl of popcorn on a wooden table.
A smiling man in a green long-sleeved shirt sits on a beige sofa in a living room, with a bowl of popcorn in the foreground, a large potted plant and shelving behind him.
A smiling man in a dark blue T-shirt sits on a couch in a dimly lit living room with a bowl of popcorn and a remote on a wooden table, a lit floor lamp and bookshelves behind him, and windows showing greenery.
A smiling bearded man in a dark green long-sleeved shirt sits on a leather couch in a living room, with a bowl of popcorn and a remote control on a wooden table in the foreground.

What usually causes it

A thermocouple that's worn out is the most common reason a pilot won't stay lit. It sits in the pilot flame and tells the gas valve the flame is burning. Once it weakens, it reads the flame as out even when it isn't, and the valve shuts the gas off. Drafts can do the same thing by blowing the small flame out directly, and a dirty pilot orifice can starve it of gas until it's too weak to hold. Each of these looks the same to you: the flame won't stay lit. But a contractor has to check which one it actually is before fixing it.

Why it's worth fixing now

A pilot that keeps going out on a boiler running most of the day through a New York winter means more relighting, and each one is a few minutes without heat while you deal with it. Left alone, a thermocouple that's failing tends to get worse, not better, until the pilot won't hold at all. With gas heating most homes here and power costing what it does, a boiler that's shutting itself off on safety checks isn't running the way it's supposed to, even on the nights it does light.

Winter nights average 24°F statewide

At 24°F overnight, your boiler isn't cycling on and off, it's running long stretches to keep up. A thermocouple already struggling to read the pilot flame gets more chances to fail during a cold snap than it would in a mild one.

NOAA nClimDiv 1991-2020 county normals weighted by homes

A pilot that won't stay lit on a night in the 20s means no heat while you sleep, not just an annoying relight. You'll notice it as cold radiators or cold baseboards in the morning, maybe a chill in whichever room is farthest from the boiler first. Relighting it yourself buys you a few hours or a few days, but if the thermocouple is the problem, it will go out again, usually when you'd rather not be crouched at the boiler with a lit match. Put off the repair and you're not saving money. You're paying to reheat a cold house every time the pilot fails, on top of electric rates that are already high here. There's also the gas smell to think about if the valve isn't shutting off cleanly when the flame reads false. That's not something to wait on through a cold snap.

A woman in a dark gray sweater reclines on a couch with her eyes closed and a knit blanket over her lap, an open book resting face-down in front of her, with a lit table lamp and shelving blurred in the background.
A bearded man in a dark navy sweater over a collared shirt smiles and looks off to the side while seated at a dinner table with a glass of red wine, a lit candle, and a plate of food in the foreground of a dimly lit room.
  1. Gas flows to the pilot and the burner waits

  2. The pilot flame heats the thermocouple's tip

  3. The thermocouple sends a small voltage to the gas valve

  4. That voltage holds the valve open and keeps gas flowing

An older oil-fired boiler with a burner unit, flue pipe, expansion tank and copper piping stands in the corner of a concrete-floored basement with weathered plaster walls.
Before you get your boiler repair
A gray boiler on a concrete pad in a basement corner, connected to copper and black pipes with a gauge, circulator pump, and gray expansion tank, beside a wood-framed wall.
After you get your boiler repair

A boiler pro near you

A pilot that won't stay lit doesn't fix itself, and each time it goes out in the middle of a cold night, you're the one climbing down to relight it. In a New York winter that can mean doing this every few days for months. A thermocouple that's worn down enough to cause the problem keeps wearing down, and a boiler that keeps shutting its pilot off is one bad cold snap away from not coming back on at all, with your gas bill already higher than it needs to be from a system working harder than it should. Getting a licensed contractor to look at it ends the guessing and the nightly relighting. You stop checking the pilot before bed and stop planning around a boiler that might quit overnight. Send the request and let someone who does this for a living take it from here.

A pilot that won't stay lit

  • A pilot that won't hold a flame almost always comes down to a worn thermocouple, not something you did wrong.
  • Relighting it every few nights through a New York winter is a sign the part has failed, not a chore you have to keep doing.
  • Cold radiators or baseboards on a 20-degree morning mean the boiler had no heat to send, not that it ran out overnight.
  • A repair here is a thermocouple swap, a quick job once someone's in front of the valve.
  • Sending the form is the last thing you have to do yourself; finding the right contractor for your boiler stops being on you.

A pilot light that keeps going out is a worn thermocouple telling the gas valve the flame is out when it isn't. That's the short answer, and it holds true whether this is the first time it's happened or the tenth. The part has done its job for years, reading the same small flame, and it just wears past the point of reading it right. Nothing about how you run the boiler caused this.

Where it leaves you is cold radiators or cold baseboards on a morning when it's 20 degrees outside, because a pilot that's out means a burner that never got the signal to fire. Relighting it gets the heat back for a night or two, maybe less if the part has gotten bad enough. That's not a routine you're stuck doing all winter. A thermocouple is a small part, and swapping it is quick work once a licensed contractor is there with the valve open in front of them.

You don't have to track down who does that kind of work or figure out who's available on short notice. Send the form and that search is handled for you. Someone who knows your way around a gas valve gets matched to what's happening in your house, and reaching out from there is on them. What's left for you is heat that stays on through a cold night without you climbing down to a pilot light again.

A lit ceramic table lamp with a linen shade sits on a round wooden side table with a small vase of greenery and a dark shallow bowl, beside a beige upholstered sofa with a cushion and knit throw, below a framed artwork on a pale wall.
Corner of a beige linen sofa with a large woven cushion and a fringed knit throw, beside a potted leafy tree in a woven basket against a neutral wall.
Sunlit interior corner with a wood-framed armchair with beige cushions and a striped pillow, a leafy plant in a tall ceramic pot, a window with wood sill showing green foliage outside, and dark wood flooring.
A lit black path light beside a stone walkway leading to a dark front door of a white clapboard house, with shrubs and flowering plants in the bed at dusk.
A covered porch at dusk with a wooden front door, a lit lantern wall sconce on gray horizontal siding, a black rocking chair with a cream throw, a potted white flowering plant, a coir doormat, and a window showing a lit interior lamp.

A local pro for your boiler repair

Send the request today and let a boiler pro reach out to you.

Get a local pro

It costs nothing to send, and you don't have to hire anyone.